搜索结果: 1-8 共查到“工学 Injector”相关记录8条 . 查询时间(0.156 秒)
Injector Waveform Monitoring of a Diesel Engine in Real-Time on a Hardware in the Loop Bench
HIL FPGA Real-Time Injector Waveform Diesel Engine
2015/1/12
This thesis presents the development, experimentation and validation of a reliable and robust system to monitor the injector pulse generated by an Engine Control Module (ECM) and send the correspondin...
High Speed Flow Simulation in Fuel Injector Nozzles
High Speed Flow Simulation Fuel Injector Nozzles
2014/10/23
Atomization of fuel is essential in controlling combustion inside a direct injection engine. Controlling combustion helps in reducing emissions and boosting efficiency. Cavitation is one of the factor...
Performance comparison of aero-ramp and transverse injector based on gas-pilot flame
dual-mode scramjet aero-ramp injector transverse injector gas-pilot flame mixing and combustion performance
2014/5/15
A direct performance comparison between the four-hole aero-ramp injector and single transverse injector in a dual-mode scramjet combustor was conducted. The mixing characteristics of two injectors wer...
高压涡旋喷油器喷雾撞壁机理研究（Spray Impingement Characteristic of GDI High-pressure Swirl Injector）
汽油缸内直喷 高压涡旋喷油器 喷雾撞壁 机理
2010/12/29
为了研究直喷式汽油机高压涡旋喷油器喷雾撞壁机理，测量了撞壁喷雾的高度、喷雾半径及喷雾远端速度，分析了不同喷射压力、环境背压、喷嘴到壁面的距离、壁面倾角等因素对撞壁喷雾的影响。随着喷射压力、喷嘴到壁面的距离及壁面倾角的增加，喷雾的贯穿距离增大；环境背压的增大导致喷雾的贯穿距离减小。较高的喷射压力和较低的环境背压增大了撞壁燃油与壁面的接触面积，在壁面上形成的薄膜加速了燃油的蒸发。由经验公式计算得到的撞...
压电式高压共轨喷油系统喷油量波动特性试验（Investigations into Multiple-injection Fuel Quantity Fluctuation for High Pressure Common Rail System with Piezo-actuated Injector）
压电喷油器 高压共轨 油量波动
2010/12/28
研究了压电式高压共轨喷油系统多次喷射过程中影响主喷油量波动的因素，采用EFS IFR8420型单次喷射仪对预喷和主喷的油量及喷油速率进行精确测量，总结了主喷油量波动的影响因素及其变化规律:预喷油量越小、主预间隔时间越短，主喷油量波动幅度越大，且随着主预间隔时间的增加，主喷油量呈周期性波动且波动幅度逐渐衰减。通过试验确定了预喷产生的压力波动是导致主喷油量波动的主要原因，为后续的多次喷射控制策略的设计...
Optimization and Evaluation of Coil Gun as a Target Injector for Laser Fusion
Laser fusion energy Targets Injector Coil gun
2009/6/8
Target injector is an essential device to be established for a laser-fusion reactor. This paper describes current status of the injector research and introduces our research results of a coil gun. The...
内燃—直线发电集成动力系统的喷油器流量特性（Flux Characteristic of Injector for Internal Combustion Linear Generator Integrated Power System）
内燃机 直线电机 喷油器
2009/5/22
为确定符合内燃—直线发电集成动力系统（ICLG）工作要求的电控喷油器，在分析喷油器工作原理的基础上，建立了一套用于喷油器流量特性研究的测控系统。本文利用该系统对所选用的喷油器进行了流量特性测试，得到了其动态流量特性曲线，并通过误差分析和电流信号分析，最终确定了该喷油器的喷油量计算公式，为燃油量的精确控制提供了依据。
Environmental Pollution Assessment of Different Diesel Injector Location Of Direct-Injection Diesel Engines: Theoretical Study
Diesel engine emissions variable injector location simulation of diesel engine
2008/12/26
An Analytical investigation on the effect of injector location of a four-stroke DI diesel engine on its pollutants’ emissions was carried out under different injector locations ranging from central to...
